ImagInk Anti-slip Glass Brochure

PRODUCT & PROFESSIONAL ADVICE DISCLAIMER

This article is provided for general information and educational purposes only. While every effort has been made to ensure accuracy as of the publication date, building codes, Australian Standards, and regulations are subject to change and may vary between states and territories.This information should not be relied upon as a substitute for professional advice specific to your project and is intended as a general reference only. Users should always consult with a qualified structural engineer for project-specific design requirements; a registered building surveyor for compliance verification; your local building authority for current regulations in your area; and/or a licensed builder or certified glass installer for installation requirements.

Limitations of Liability: Cooling Brothers Glass Company Pty Ltd: Makes no warranty as to the suitability of products for any particular purpose; Disclaims all liability for any loss or damage arising from reliance on this information; Accepts no responsibility for errors, omissions, or misinterpretation of this documentation; Reserves the right to modify specifications and performance data without prior notice.

Technical Documentation and Performance Data Notice: The information contained in this document is provided by Cooling Brothers Glass Company Pty Ltd for general guidance only. While every effort has been made to ensure accuracy at the time of publication, this information should not be considered a definitive guide to product selection or installation.

Performance Data: All Low-E glass performance data, including U-values, Solar Heat Gain Coefficient (SHGC), Visible Light Transmission (VLT), and other thermal performance indicators, are: Calculated using industry-standard software (LBNL Window software) under NFRC 100-2001 environmental conditions; Based on centre-of-glass measurements and do not account for frame effects or edge conditions; Representative of typical production values and may vary due to manufacturing tolerances; Subject to change without notice as products are continuously improved.